Technical -> Buck-Boost

	Buck-Boost

The Buck – Boost system is a means of connecting a transformer to add or subtract a voltage to the existing supply voltage. The simplest form of Buck-Boost transformer is the autotransformer. Here a section of the winding is used to increase or decrease the output voltage in relation to the input voltage. The adjusting part of the wind is the “over wind” the rest of the coil is the “common wind”

A more complex form of this is where the voltage being added to or subtracted from is different to the reference input voltage. In such a case an isolation transformer is used to separate the common part of the autotransformer winding from the over wind.

Consider the following circuit.

Here a variable transformer is used to provide an adjustable input to the primary of the Buck-Boost transformer. One end of the primary of the buck-boost transformer is connected to the center tap of the variac the other end to the wiper. In this way the primary voltage of the transformer ΔV_P can now be varied from -V_S/2 to +V_S/2. The secondary of the buck boost transformer ΔV_S will therefore vary

From

to

Where N_S and N_P are the secondary and primary turns respectively
Connecting one end of the secondary coil to the main supply voltage V_S will result in an output of the Buck-Boost system

From

to

The rating of the Buck-Boost transformer will be considerably less than that of an isolation transformer providing the full voltage at the required current.

The rating of the variac will be given by

A similar system works for three phase circuits using a 3 phase variac and 3 phase transformer

Note these types of system are only really suitable for small levels of adjustment (Approximately ±20% of the supply voltage) as used for example in testing equipment. Beyond this the cost benefits do not justify the use of a Buck-Boost solution